Table of Contents
Advertisement
ASSEMBLING LEGSTAND (Continued)
• Align the two large holeson the brace and the legs,
Insertthe carriage bolts, Add fiat washers and hex
nutsand hand tighten, Repeat for the other short
upper brace, These are the frontand beck sets.
•
Forthe sides, installa long upper brace on two
legs.Add hardware and finger tighten. Repeat for
the other long upper brace.
•
Use the same stepsto installthe lower braces,
Tighten all hex nutswith a 12 mm wrench,
•
Place a hex nut and flat washer on each leveling
foot, Install the leveling feet from the bottomof
each leg with the boltspointingup. Secure with a
flit washer and hex nut but do not tighten,
•
Move the leg stand to desired location.Adjust the
levelingfeet with a 12 mm wrench, then securely
tighten the top hex nut,
_.
WARNING:
Do not liltthe sew table without
help. The table saw base weighs approximately
95 Ibs. Hold it close to your body. Keep your
knees bent and lift with your legs, not your beck.
Ignoringthese precautionscan result in beck
Injury,
•
Place the leg stand on the table saw base. Align
the holes in the table with the holes in the end
braces, Make surethe Craftsman libel faces the
frontof the saw (same side as height handwheel),
•
Place a fiat washer on each bolt and insertthrough
hole. Add a fiat washer and a hex nut. Hand
tighten.
•
Repeat for the three remainingholes. Tighten all
hardwarawith a t2 mm wrench. You may find it
helpfulto use two wrenches, one wrenchto hold
the head of the bolt and one to tighten the hex nut.
Leave the sew upside downto add table exten-
sions,
LEG STAND
FLAT WASHER
HEX
LEGSTAND SHOWN A,.%qBIBLED
Fig. 8
MOUNTING THE LEG STAND ON THE TABLE
SAW BASE
See Figure 9.
• Take the followingfrom the hardware bag:
4 hex bolts(5/16-18 x 3/4 in.)
4 hex nuts (5'16-18)
8 fiat washers (5116 in.)
Note: This herdwam was in the beg with hardware for
assemblingthe leg stand and levelingfeat.
•
Place the saw table upside down on a smooth
surface,such as cardboard, on the floor,
19
SAWBASE
Fig. 9
CRRFTSNNFI'ABLE SAW 315.221B90
Advertisement
Table of Contents
