Table of Contents
Advertisement
GENERAL
MAINTENANCE
_1, WARNING:
When servicing,use only identical
Craftsman replacement parts.Use of any other
pert may create a hazard or cause product
damage,
_1= WARNING:
To prevent accidental starting that
could cause possible serious personal injury,
turn off the saw, remove the switch key, and
unplugthe saw before working on the table saw.
•
Remove sawdust from the rails, top surface,and
inside of saw frequently,
•
Clean plasticparts with a softdamp cloth, Do not
use any strong solvents.
_i,
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc. contact plastic parts, They contain
chemicals that can damage, weaken or destroy
plastic,
•
Pedodically clean the table, rails, and dp fencawith
gum and pitch remover. Do not allow pitch to
accumulate on the saw.
• Apply a thin coat of paste wax to the table top so
the wood slides easily while cutting.
•
Regularly check all nuts, bolts, screws, and belts
for tightness and condition.Make sure the throat
plate is in good condition.
MOTOR / ELECTRICAL
•
Frequentlyvacuum or blow out any sawdust from
the motor.
,_k WARNING:
If the power cord is worn, cut, or
damaged in any way, have it replaced immedi-
ately by a qualified service technicianat a Sears
store or repair center. Failureto do so could
result in sedous personalinjury.
WARNING:
To avoid fire or electrocution,
reassemble electdc partswith only identical
Craftsman replacement parts. Reassemble
exactly as originallyassembled.
This saw has been lubricated at the factory pdorto
shipment,After extended use, you shouldinspect,
clean, and lubricate the areas shown in the drawing.
Clean before lubricatingwith a solvent recommended
for gum and pitch removal. Lubricatewith SAE no, 20
or no. 30 engine oil
See Figure 58.
•
Table brackets. (a)
•
Bevel handwheel rod threads and knuckle.(b)
•
Height handwheel threads and trunnion, (c)
43
B
FRONT OF_L,_W
Fig. 58
CRIIFTSNRN" TABLE SAW 315.228,1_
Advertisement
Table of Contents
