And Press; Use - Yamaha RX-V667 Owner's Manual

Subwoofer
Confirms the subwoofer.
Select this when subwoofer is connected. During
playback, the subwoofer will produce audio from the
LFE (low-frequency effect) channel and bass audio
from other channels.
Select this when subwoofer is not connected. The
front speakers will produce audio tYom the LFE (low-
frequency effect) channel and bass frequency audio
from other channels.
Phase
Sets the phase of the subwoofer if the bass audio is lacking or
unclear.
. !IIDoes
not change the subwoofer phase.
iii iii ll
.............................................. Reverses the subwoofer phase.
Extra Bass
Allows the front channel low-frequency components to be
produced exclusively by the subwoofer, or by both the subwoofer
and the front speakers.
Depending on the size of the front speakers, either the
front speakers or the subwoofer produce the front
channel low-frequency components.
The subwoofer and the front speakers produce the
front channel low-frequency components.
When "Subwoofer" is set to "None" or "Front" is set to "Small,"
"Extra Bass" is disabled.
Bass Cross Over
Sets the lower limit of low-frequency component which is
produced from speakers of which the size is set to "Small."
A frequency sound which is lower than the specified frequency will
be produced from the subwoofer or the front speakers. "_5,2
40Hz 110Hz
60Hz 120Hz
80Hz (Default) 160Hz
90Hz 200Hz
100Hz
Adjusts the timing at which the speakers produce audio so that
sounds from the speakers reach the listening position at the same
time.
Selecting adjustment units
Use
_Cursor z_/
v to select the unit for distance (meters or
feet), and press _jENTEN.
Setting distances for each speaker
Use _]Cursor _ / _' to select the speaker you want to configure,
and press [_ENTEN. Then use _iCursor <1 / > to set the distance
from the speaker to your listening position.
1.0 ft to 80.0 ft (0.30 in to 24.0 m)
10.0 ft (3.00 m) (Front L/Front R/Center/Surround L/
Surround R/Surround Back L/Surround Back R/Front
Presence L/Front Presence R/Subwoofer)
0.2 fl (0.05 m)
Separately adjusts the volume of each speaker.
Use
_Cursor z_ /
_ to select the desired speaker, and press
_]ENTER. Then use
_]Cursor <1 /
> to adjust the volume for the
selected speaker.
-10.0 dB to +10.0 dB
0.0 dB (Front L/Front R/Center/Surround L/Surround
R/Surround Back L/Surround Back R/Front Presence
L/Front Presence R/Subwoofer)
0.5 dB
"ibj 1 : Enabling "Extra Bass" allows both the subwoofer and the front speakers to
produce bass audio.
"{bJ2 : lfyour subwoollzr has a w)lume control or a crossover frequency control, set
the crossover frequency to maximum and the volume to half (or slightly less).
En
86