Yamaha RX-V667 Owner's Manual page 17

gennecting speakers and subweefer
Connect your speakers to their respective terminals on the rear panel.
CAUTION
• Remove the AC power cable of this unit flom the power outlet before connecting the speakers.
• Generally speaker cables consist of two parallel insulated cables. One of these cables is a different color, or has a line running along it, to indicate different polarity. Insert the different colored (or lined) cable into the "+"
(positive, red) terminal on this unit and the speakers, and the other cable into the "-" (negative, black) terminal.
• Be careful that the core of the speaker cable does not touch anything or come into contact with the metal areas of this unit. This may damage this unit or the speakers. If the speaker cables short circuit, "CHECK SP
WIRES!" will appear on the fiont panel display when this unit is switched on.
• Front/Center/Surround/Surround back speaker and
Subwoofer connection
Front speaker
R L
Surround Surround back
speaker speaker
R L R L
• Presence speaker connection
When using the presence speakers, connect the speakers to the
EXTRA SP jacks as shown in the diagram below.
Presence Presence
speaker R speaker L
The presence speakers (PL/PR) that output front effect sounds can
be connected to this unit. With the sound programs (_),
sound with a richer and more spatial presence can be created.
1.8 m
Connection of presence speakers is recommended to take full
advantage of the effects of CINEMA DSP sound programs.
Although you can connect both surround back speakers and
presence speakers to this unit, you cannot output sounds fiom
those speakers at the same time.
Center speaker Subwoofer
L__,.J L.==_J
En
17