Assembly - Weider Platinum XP800 User Manual

ASSEMBLY
This manual is dasigP_dto ensure that the resist-
ance system can be assembled successfullyby
most people. However, it is importantto realize
that the versatile resistancesystem has many
parts and that the assembly processwilltake
time. Most people find _at by settingaside plenty
of time, assembly will go sm_ly.
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
matedals until assembly is completed.
• For help identifying small parts, use the PART
IDENTIFICATION CHART. Note: Some small
parts may have been pre-attached for shipping. If
a part is not in the parts bag, check to see if it
has been pre-attached.
• Tighten all parts as you assemble them, unless
instructedto do otherwise.
• As you assemble the resistance system, make
sure all parts are oriented as shown in the draw-
ings.
The included Allen w_ _ and the fol-
lowing tools (not included) are required for
assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water,
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Attach the Base Plate Foot (63) to the Base Plate
(1) with two M4 x 38mm Screws (100).
2. Attach a Wheel (65) to a Wheel Insert (64) with an
M10 x 78mm Button Bolt (99) and an M1O Nylon
Locknut (103). Do not overtighten the Locknut;
the Wheel must be able to turn easily.
Attach the Wheel Insert (64) to the Base Plate (1)
with two M4 x 16mm Screws (53) and a Plastic
Foot (36).
Attach the other Wheel (65) in the same man-
ner.
100
p
_.-1 OO
103
64
1
53
99
5