E-Mail Setup And Network Scanning Setup - Sharp AR-PB2A Operation Manual

5. This page lets the system administrator select passwords for the entire web site (refer to the
following table). Enter a user password in the User Access to Destination List field and/or
administrator password in the Admin Control for E-mail/Scanning field.
One password for each User and Admin respectively can be registered. After entering the
passwords in both the entry and confirm locations for User and Admin, check the box of Enable
Password Protection of This Web Site and click the 'Submit' button to register the passwords.
If you enable the password protection with entering neither User nor Admin password, the password
"Sharp" will automatically be entered.
NOTE The passwords must be confirmed by entering in both fields of "User Access to Destination List" and "Confirm
Password" for the user password and "Admin Control for E-mail/Scanning" and "Confirm Password" for the
administrator password, and then select the 'Submit' button to register the passwords.
Once the passwords have been registered, you will be prompted for user name and password every
time you try to enter the web pages of the network scanning system. The user names will always be
"user" for user level and "admin" for administrator level.
Name
Enable Password Protection of This Web
Site
User Access in Destination List
Confirm Password
Admin Control for E-mail/
Scanning
Confirm Password

E-mail Setup and Network Scanning Setup

In the "Status/Alert by E-mail" function, SMTP (Simple Mail Transport Protocol) protocol is used to
send the e-mails. This section describes how to set up the basic status of the e-mail sending
including the definition of the file names for the image data to be attached and so on. Such settings
must be effected by the system administrator who has the special network related backgrounds.
Definition
To enable password protection, check the box and
click the 'Submit' button. To disable it, clear the
check mark in the box and click the 'Submit' button.
Enter a User password within 10 characters.
Enter the User password again to confirm it.
Enter an Admin password within 10 characters.
Enter the Admin password again to confirm it.
49
KEY OPERATOR'S GUIDE