Cautions On Handling The Machine; Laser Information - Sharp AR-M256 Operation Manual

Be sure to connect the power cord only to a power outlet that meets the specified voltage and
current requirements. Also make certain the outlet is properly grounded.
Connect the machine to a power outlet which is not used for other electric appliances. If a lighting fixture is
Note
connected to the same outlet, the light may flicker.
Be sure to allow the required space around the
machine for servicing and proper ventilation.
A small amount of ozone is produced within the machine during operation.
The emission level is insufficient to cause any health hazard.
Note:
The present recommended long term exposure limit for ozone is 0.1 ppm (0.2 mg/m
weighted average concentration.
However, since the small amount that is emitted may have an objectionable odor, it is advisable to place the
machine in a ventilated area.

CAUTIONS ON HANDLING THE MACHINE

Observe the following precautions when handling the machine to maintain top performance.
Do not drop the machine, subject it to shock or strike it against any object.
Store spare toner cartridges in a cool dry place without removing from the package before use.
• If they are exposed to direct sunlight or excessive heat, poor copies may result.
Do not touch the photoconductive drum (green portion).
• Scratches or smudges on the drum will cause dirty copies.

LASER INFORMATION

Wave length
Pulse times
Output power
4
785 nm +10 nm
-15 nm
North America: 25 cpm model: (6.213 µs)/7 mm
31 cpm model: (7.385 µs)/7 mm
Europe: 25 cpm model: (6.213 µs)/7 mm
31 cpm model: (7.385 µs)/7 mm
Max. 0.9 mW
30cm (12")
30cm
(12")
3
) calculated as an 8 hr. time-
30cm
(12")