Table of Contents
Advertisement
31/34
Getting Started with the HNS 9201
Select the Routing tab to display the following screen:
3.
Check the displayed APN in the Select APN field. If it is not correct, select the required
4.
APN from the drop-down list and click on OK.
TIP:
Some Distribution Partners assign usernames and passwords to the APN. You
may need to enter these when accessing or changing APN details.
4.3.
Making a WLAN connection
WLAN and the HNS 9201
For the WLAN to work, you must configure the BGAN terminal and your computers with the
same channel, network name and WEP security settings. Note the following about WLAN
channels:
•
The WLAN channels you may legally use vary in different regions of the world. In some
countries, certain channels are not available. Please be sure to select your Region from the
drop down menu before selecting one of the available channels.
•
Channel 11 is common to almost all regions and so it is used as the default channel.
•
Inmarsat recommends that you observe any local regulations regarding the use of radio
transmitting devices. In particular, note that if you are in France or Spain the channels
available for selection are limited.
The HNS 9201 has a built-in WLAN 802.11b Access Point. By default, the WLAN interface is
disabled. Use BGAN LaunchPad to enable and set up the WLAN interface after registration as
follows:
Advertisement
Table of Contents
