Regency Horizon HZ54E-NG Owners & Installation Manual page 41

9) Install 4 - AA batteries into the receiver, ensure correct polarity.
10) Plug receiver wires into the back of the receiver and bundle wires
with the wire clip as shown below.
11) Connect GTM motor wire from the stepper motor to the wire connector
from the receiver wire harness.
12) Program Receiver and transmitter (refer to manual)
Note: DO NOT USE 4 AA batteries in the battery pack on the tray; the
DFBC is now powered by the receiver batteries in the wall.
Regency Horizon HZ54E Gas Fireplace
Wire Clip
INSTALLATION
41