Epson EMP-7100 Owner's Manual page 24

4. Connect one end of the power cable to the projector's power
connector. Connect the other end to an earthed electrical socket.
The projector should be in sleep mode, indicated by an orange
power indicator.
Warning: Never look into the lens when the projector is on. There is a
risk that the projector might come on suddenly even though it is not
in use. The light from the lamp can damage your eyes. It is especially
important that children should not be allowed to look into the lens.
5. To insert the batteries in the remote control device, slide off the
battery compartment cover as shown below.
6. Insert the two AA batteries included with the projector. Make
sure the polarity of the batteries is correct.
7. Replace the battery compartment cover.
6 1 • Installation