Craftsman 536.773600 Operating Instructions Manual page 13

LUBRICATION
MAINTENANCE
How To Lubricate
The Jackshaft Assembly
A grease fitting is provided to lubricate the
jeckshafl assembly, Use e grease gun with au-
tomotive type grease to lubricate the jaskshaft
assembly as shown in Figure 10.
How To Change Engine OII
Change the engine oil when the engine is
warm. Forthe properoil capacity, s ee "Product
Specifications".
1. Disconnectsparkplugwire fromthe spark
plug.
2. Remove the oil drain plug as shownin
Figure11.
3, Drain all the engine oil into a fiat pan.
4. Install the oll drain plug. Make sure the
oil drain plug is tight.
5. Remove the dipstick.
6. Fill the engine crankcase. DO NOT
OVERFILL. For properoil capacity,see
=Product S pecifications".
7. Connect the spark plugwiretothespark
plug.
HOW TO REPLACE THE AIR FILTER
Replacethe airfilteroncea yearor more often
in dustyor dirtyco_rlJcos.DO NOT attemptto
clean or oilthe air filter.Remove and installa
new air filteras follows:
CAUTION: Never run the engine without
the air filter Installed. An air filter clogged
with dust can result In loss of engine power
and can cause excessive wear or damage
to the engine. If the air filter Is clogged, re-
place Immediately.
1. Disconnectthe spark plug wire from the
sparkplug.
2. Turn the cover clockwise as shown in
Figure 12, Remove the cover and the air
filter.
3. Discard the old air filter.
5. Put the new air filter into the cover.
6. Pushthe cover firmlyagainst the flange.
Turn the cover counterclockwiseuntil
tight. Be sure the retainers are locked
around the flange.
7. Connect the sparkplug wire to the spark
plug.
Air Filter
4. Clean the cover and the flange.
F_210M 13