Craftsman 536.773600 Operating Instructions Manual page 7

ASSEMBLY
HOW TO RAISE THE HANDLE
f. Hold the handle with one hand and loosen both handle adjustment knobs unUlthe ratchet
teeth are disengaged. Do not remove the handle adjustment knobs. See Figure 2.
2. Raise the handle to the
operating position.
3. Stand in the operator's Handle
position behind the trim-
mer. Put the handle in a
comfortable position.
Make sure both sides of
the handle are level.
NOTE: Make sure the
cables ere not caught
between the upper and
lower handle.
4. Tighten the handle ad-
justment knobs. Make
sure the handle pivots
are locked in place.
NOTE: The handle
height is adjustable.
See "How To Adjust
The Height Of The Han-
dle" in the Adjustment
section.
5. To attach the recoil start handle to the rope guide, twist the rope through
the rope guide mounted on the right side of the handle.
ENGINE PREPARATION
Fill Crankcase With OII
The trimmerwas shippedwith a container of
SAE30 motor oil.Thisoilmustbe added tothe
enginebeforeoperating.
1. Remove the oil fillcap/dipstickshown in
Figure3. Fill the crankcase to the FULL
line on oil fillcap/dipsUck. DO NOT OVER-
FILL.
2. Installthe oil fill cap/dipstickand tighten
securely.
Fill Fuel Tank With Gasoline
For the correct procedure and grade of
gasoline,see =How To Fill With Gasoline"in
the Operationsection.
Figure
_" CHECKLIST
For the best performance and satisfaction
from this quality product, please review the fol-
lowing checklist before you operate the trim-
mer:
_" All assembly instructions have been
completed.
Check carton. Make sure no loose parts
remain in the carton.
F-OO0210M 7
As you learn how to use the tdmmer, pay extra
attention to the following important items:
v'P" Engine oil is at correct level.
v'P" Fuel tank is filled with fresh, clean, reg-
ular unleaded gasoline.
P"P_ Become familiar and understand the
function of all controls. Before your start
the engine, operate all controls.