Memory Switch Functions; Tm-L90 Memory Switch Settings - Epson TM L90 Technical Reference Manual

2.9 Memory Switch Functions

This printer has the following software switches, called memory switches, in the non-volatile
memory.
• Msw 1, Msw 2, Msw 8
• Customized values
• Serial communication conditions
These settings can be made by the memory switch setup utility (see page 4-7) or ESC/POS
commands. Refer to the "ESC/POS Application Programming Guide" for details of the
commands.

2.9.1 TM-L90 memory switch settings

Some settings of Msw 2 and Msw 8 can be made in the memory switch setting mode. (See page
2-27)
MSW1
Bit Function
1 Send power on notification
2 Select receive buffer capacity
3 Conditions for Busy status
4 Data processing when reception error occurs
5 Automatic line feed
6 Reserved
7 #6 pin: Select reset signal
8 #25 pin: Select reset signal
Msw 1-7, 1-8 are effective only when serial interface is used.
*: Factory setting
MSW2
Bit Function
1 Reserved
2 Autocutter operation
3-8 Reserved
*: Factory setting
Rev. B
TM-L90/TM-L90 with Peeler Technical Reference Guide
0 (OFF)
Not sent *
Large (4K bytes) *
Receive buffer full or
offline *
Substitute with "?" *
Invalid *
Fixed *
Not used *
Not used *
0 (OFF)
--
Disabled
Fixed to OFF
1 (ON)
Sent
Small (45 bytes)
Receive buffer full
Ignored
Valid
—
Used
Used
1 (ON)
Fixed to 1 (ON) (do not
change setting) *
Enabled *
--
Setup 2-35