Tm-L90 Peeler Specification Memory Switch Settings - Epson TM L90 Technical Reference Manual

2.9.2 TM-L90 peeler specification memory switch settings

Among the settings shown below, some can be set with the memory switch setting mode. Refer
to page 2-27.
MSW1
Bit Function
1 Send power on notification
2 Select receive buffer capacity
3 Conditions for Busy status
4 Data processing when reception error occurs
5 Automatic line feed
6 Reserved
7 #6 pin: Select reset signal
8 #25 pin: Select reset signal
Msw 1-7, 1-8 are effective only when serial interface is used.
*: Factory setting
MSW2
Bit Function
1 Reserved
2 Reserved
3-8 Reserved
*:Default setting
MSW7
Bit Function
1-7 Reserved
8 FEED button operational settings
(applied only during printing with
continuous issuing)
*: Default setting
2-38 Setup
0 (OFF)
Not sent *
Large (4K bytes) *
Receive buffer full or
offline *
Substitute with "?" *
Invalid *
Fixed *
Not used *
Not used *
0 (OFF)
--
--
OFF fixed
0 (OFF)
--
Moves the paper to the next
printing start position
1 (ON)
Sent
Small (45 bytes)
Receive buffer full
Ignored
Valid
—
Used
Used
1 (ON)
Fixed to 1 (ON) (do not change
setting) *
--
1 (ON)
--
Pressing FEED once moves the paper
to the manual cutter
position.Pressing FEED twice moves
the paper to the next label printing
start position.Thereafter, pressing
FEED repeats the operation above.
Rev. B