Unpacking - Craftsman 320.27669 Operator's Manual

Disconnect the tool from the power source before making any
adjustments or changing cutter bits.
if you are changing a bit immediately after use, be careful not to touch
the collet/nut or cutter bit with your hands or fingers. The heat buildup
from cutting could cause severe burns. Always use the wrench provided.
Avoid "climb cutting;" see "OPERATION" section in this manual "Climb cutting"
increases the chance for loss of control resulting in possible serious injury.
,_ WARNING: Your router should never be connected to the power source
when you are assembling parts, making adjustments, installing or removing bits,
cleaning, or when it is not in use. Disconnecting the router will prevent accidental
starting, which could cause serious personal injury.
When unpacking the box, do not discard any packing materials until all of the
contents are accounted for:
1.
2.
Carefully lift the router out of carton and place it on a stable, flat surface.
Open the carton to locate the following:
• Vacuum port and 2 screws used to attach it to the base
Chip shield ( already installed on router )
1/4 inch .collets/nut ( (the 1/2 in. collet/nut is already installed on router )
Collet/nut wrench
Depth-Adjustment Wrench
• Edge Guide
Manual
3. Inspect the items carefully to make sure that no breakage or damage has
occurred during shipping. If any of the items mentioned is missing, (refer to
"PARTS LIST" illustration), return the router to your nearest Sears store to
have the router replaced.
WARNING: If any part is broken or missing, do not attempt to assemble the
router, plug in the power cord, or operate the router until the broken or missing
part is replaced. Failure to do so could result in possible serious injury.
27669 ManuaLRevised_11 0215 Page 10