Setting The Router - Craftsman 320.27669 Operator's Manual

NOTE: If the inner screws wear down or
require calibration:
* Pull the lever up and turn it clockwise and
then push the lever down (Fig.13).
* Turn the lever counterclockwise to secure
the edge guide.
SETTING THE ROUTER (Fig. 14}
,_ WARNING: When set the digital screen;
make sure to turn the toggle on/off switch
to the "Off" position. Failure to do so could
result in accidental starting.
1.
2.
3.
4.
5.
6.
Place the router on a flat workplace; make
sure the bit is not contacting the workpiece.
Fig. 14
Turn the toggle on/off switch to the
"Off" position.
Plug the digital router in power source,
LCD screen reads the specifications of
the router (Fig. 14).
Press the key "SET", the type of bit
begins flashing. Press "+" or "-" to choose the bit type needed.
Re-press "SET", the size of bit begins flashing. Press "+" or "-" to choose
the bit size needed.
7.
8.
9. Turn the toggle on/off switch to ON.
10. The motor will run per pre-setting speed.
NOTE: If the operator wants to control the
speed manually, Directly Press "+" or "-" to
choose speed without pressing "SET" key.
NOTE: when the motor is running, "SET" key
is useless, operator can only select "+" or "_"
to change speed.
ELECTRONIC VARIABLE SPEED
CONTROL (Fig. 15}
NOTE: The below chart and all the
specifications appear on the display of the
router are only for reference for your operation.
27669 ManuaLRevised_11 0215
Re-press "SET", the material hardness of workpiece to be cut begins
flashing. Press "+" or "-" to choose the material of workpiece to be cut.
Re-press "SET" again, exit the setting system.
The setting speed was displayed on digital screen.
Fig. 15
Page 22