Chery QQ6 Service Manual page 60

The method to adjust the
clock display
follows:
Press the clock adjustment button on the
vehicle instrument to adjust the right area
of LCD display to the clock display
mode. In this case, press the clock
adjustment button and keep it for
approximate 4 s. And the HOUR digit of
the digital clock will frequently flash.
Press the clock adjustment button to
adjust the hour digit of the clock, with
one hour increament every one press.
Pressing the button for a long time will
automatically increase the value of
HOUR digit; after the completion of
HOUR digit adjustmenet, about 6 s later,
the MIN digit of the digital clock will
automatically flash. In this case, press the
clock adjustment button to adjust the
MIN digit of the clock, with one minute
increament every one press. And pressing
is as
this button for a long time will
automatically increase the value of MIN
digit.
After the completion of time adjustment
of the clock, several seconds later, the
digital clock doesn't flash any more. It
indicates that the time of clock is
corrected.
Tachometer
It is used to display the engine speed
(rpm).
Instrument Panel
The red area in the upper right side of the
dial represents the highest allowable
speed range that the engine can get in a
short period of time under the operating
temperature of the engine after its
running-in.
However, it is recommended to push the
shift control rod into the next higher gear
or remove your leg from the accelerator
pedal when the needle reaches this zone.
NOTICE:
Entering into the next higher gear early is
favorable to save fuel and decrease the
driving noise.
Once you find the engine operates
unsteadily, please immediately shift the
control rod into the next lower gear.
During the running-in period,
DO NOT let the engine
operate at high speed!
60