Chery QQ6 Service Manual page 35

DRIVING
Start-up
Preparatory work before
start-up
The start-up of engine is controlled by
the electric control system of the
engine.
To start up the electronic injection
engine, do not step on the gas pedal
before and during starting. You step on
the gas pedal only when it is a poor
start. For the details about the start of a
vehicle, see the Section ―Start-up of
engine‖ of this chapter.
Safety considerations
The idling speed of an engine is
controlled by the electric control
system. The idling speed is high when
the engine starts, which
advantageous to increase
temperature of the engine. After the
temperature of the engine rise, the
idling speed shall
automatically. If the idling speed fails
to decrease automatically, you shall get
to the Chery Authorized Service
Station to make your vehicle repaired.
Do not make the engine operate at the
speed, which is more than the specific
idling speed, for above 10 minutes.
Before the vehicle starts:
1. Confirm that all passengers fasten
The long-time high-speed idling
of DO NOT start up your vehicle an
over-high temperature of the on the airproof garage or other
engine and exhaust system, which has enclosed locations. The exhaust
the risk of firing and other damages. gas from a vehicle is noxious. The door
Therefore, DO NOT make your vehicle of garage must be opened before the
stop, travel at idle speed or run on the engine starts. For the details, see the
section ―Caution against the exhaust
ground where there are hay or other dry
fume from a vehicle‖ in this chapter.
coverings. The exhaust system may
is
make the temperature of the engine
compartment and exhaust pipe rise up,
the
which it may cause a fire.
their safety belt. For the safety
belt and its instruction, see the
decrease
Chapter
Protection‖
2. Confirm that the front headlamp
and other electrical accessories
power off.
3. Confirm that the handbrake is
pulled up.
4. Confirm that the selector lever is
in NEUTRAL position.
Driving
engine may create
―Seat and Safety
35