Chery QQ6 Service Manual page 114

the clip of bulb holder by hand to
make the clip go across the
locating groove and then separate
the clip to both sides, take out the
bulb and pay more attention to
the locating mark of the bulb.
4. CAUTION: DO NOT tauch the
surface of new bulb by hand so as
to avoid the influence on the
brightness of bulb. The lighting
system is a safety part. Please
note that any detailed operation
shall be correct
replacement. If necessary, please
get to the CHERY Authorized
Service Station to
repaired.
High Beam
It is difficult to replace the bulbs of
front turn signal and position lamps. If
when
these bulbs have some troubles, please
get to CHERY Authorized Service
make it
Station in time to make these lamps
repaired.
Front fog lamp bulb
To replace the front fog lamp bulb,
please get to the CHERY Authorized
Service Station to replace it.
Emergency Assistance
Low Beam
Tail lamp bulb
Position and Stop lamps
Turn Signal Lamp
If the tail lamp fails to work due to the
damage of its bulb, please replace the
corresponding bulb according to the
following procedures.
1. Open the tail door, and unscrew
in the anticlockwise direction two
nuts (under the sound isolation
gasket) used to fasten the tail
lamp from the internal side of
luggage boot. Then unscrew three
fixing bolts in the anticlockwise
Fog Lamp
Backup Lamp
114