Digital Connections; Adjusting The Voltage Selector; Connecting The Power Cord - JVC RX-6042S Instructions Manual

Getting Started

Digital Connections

By connecting the receiver and the source component through the
digital terminals, sound reproduction quality will be much improved.
In addition, you can enjoy multi-channel reproduction and some
other convenient functions.
IMPORTANT:
• When connecting a video component using the digital
terminals, you also need to connect it to the video jacks on
the rear. Without connecting it to the video jacks, you can
view no playback picture.
• After connecting the components using the DIGITAL IN
terminals, set the following correctly if necessary.
– Set the digital input (DIGITAL IN) terminal setting correctly.
For details, see "Setting the Digital Input Terminals" on
page 22.
– Select the digital input mode correctly. For details, see
"Selecting the Analog or Digital Input Mode" on page 13.
Digital input terminals
You can connect any digital components having coaxial or optical
digital output terminal.
Digital coaxial cable (not supplied)
between digital coaxial terminals
Digital optical cable (not supplied)
between digital optical terminals
When the component has a digital
coaxial output terminal, connect it to
the DIGITAL 1 (DVD) terminal, using a
digital coaxial cable (not supplied).
When the component has a digital
optical output terminal, connect it to the
DIGITAL 2 (CD)—or DIGITAL 3 (TV)
for RX-6042S—terminal, using a digital
optical cable (not supplied).
Before connecting a digital
optical cable, unplug the
protective plug.
10
Notes:
• When shipped from the factory, the DIGITAL IN terminals have
been set for use with the following components:
– DIGITAL 1 (coaxial): For DVD player
– DIGITAL 2 (optical): For CD player
Only for RX-6042S:
– DIGITAL 3 (optical): For digital TV broadcast tuner
• When you want to operate the CD player or CD recorder using the
COMPU LINK remote control system (see page 30), connect it also
as described in "Analog Connections" (see page 7).
• When you want to operate a DVD player or TV using the AV
COMPU LINK remote control system (see page 31), connect it also
as described in "Analog Connections" (see pages 8 and 9).

Adjusting the Voltage Selector

Before connections, always do the following first if necessary.
Select the correct voltage with the VOLTAGE SELECTOR switch
on the rear using a screw driver.
Check to be sure if the voltage mark is set to the voltage for the area
where you use this unit.
Voltage mark
DIGITAL 1
(DVD)

Connecting the Power Cord

DIGITAL 2 (CD)
Before plugging the receiver into an AC outlet, make sure that all
connections have been made.
DIGITAL 3 (TV)
Plug the power cord into an AC outlet.
• Keep the power cord away from the connecting cables and the
DIGITAL IN
antenna. The power cord may cause noise or screen interference.
Notes:
• The preset settings such as preset channels and sound adjustment
may be erased in a few days in the following cases:
– When you unplug the power cord.
– When a power failure occurs.
• If the wall outlet does not match the AC plug, use the supplied AC
plug adaptor.
CAUTIONS:
• Do not plug in before setting the VOLTAGE SELECTOR
switch on the rear of the unit and all connection procedures
are complete.
• Do not touch the power cord with wet hands.
• Do not pull on the power cord to unplug the cord. When
unplugging the cord, always grasp the plug so as not to
damage the cord.
VOLTAGE SELECTOR
110V
220V
127V
230 - 240V