Filling Solution Tank - Windsor SPIRIT DUAL SPD-J Manual

Preparing the SPIRIT DUAL:
For Hard Floor:
1.)
Install the optional kit : Vac Shoe Squeegee (p/n
02285). Raise the SPD vac shoe and place the squeegee
assembly over the vac shoe intake. Center the squeegee
on the vac shoe and secure by tightening the two retain-
ing knobs.
CAUTION: Make sure that the machine is un-
plugged, switches are turned off and both solution
tanks are empty before beginning brush removal or
replacement.
2.) Now install the hard floor brush. Tilt the machine
back far enough to grasp the brush. If the carpet brush
is already installed, proceed with step 3 to remove it.
If no brush is installed, proceed with step 4.
To remove brush, pull the brush release knob
3.)
back until the brush can be swung out from the housing
and pull the brush off of the drive end.
4.) To replace, align the pulley drive pins on the knob
driver in the housing with the slots in the brush and
slide over the knob driver.
5.) Pull the brush release knob back, align the flat
sides of the brush stub axle in the housing and swing
the brush into place. Then release the knob, returning
Refer to page 17 for parts
to the locked position.
outlined in these steps.
6.) Set the water control switch on the front of the
NOTE: If water does not spray
machine to "LOW".
after 5 seconds when the switch is in the "LOW"
position it may be necessary to place it in the
"HIGH" position to start the flow, then return it to
the "LOW" position for hard floor use.
For Carpet:
1.)
Remove squeegee from vac shoe by loosening
the two retaining knobs.
2.) Install carpet brush as described above.
3.) Set the water control switch on the front of the
machine to "HIGH".

Filling Solution Tank:

1.) Set dome and recovery tank to the side.
2.) Use a clean bucket to fill the solution tank
with hot water.
3.) If necessary add a cleaning concentrate for
use in hot water extractors. Closely follow manu-
facturer' s instructions found on container. Read
ingredients listed on the container to ensure com-
CAUTION: Use only the suitable chemicals
listed below. Using incompatible chemicals will
damage the machine. Damages of this type are
not covered under warranty. Carefully read
ingredients on manufacturer' s label before us-
ing any product in this machine.
SUITABLE INCOMPATIBLE
CHEMICALSCHEMICALS
Alkalis
Clorox II Bleach*
Defoaming Agents
Detergents
Hydroxides
Oxygen Bleaches
Soaps
Sta-Puf Fabric Softener*
Vinegar
White Monday Bleach*
Registered Trademark
l
4.) Place the recovery tank onto the solution tank.
5.) Set the dome in place on the recovery tank.
Dome must be seated correctly to ensure
proper vacuum seal.
Aldehydes
Aromatic Hydrocarbons
Butyls
Carbon Tetrachloride
Chlorinated Bleaches
Chlorinated Hydrocarbons
D-Limonene
Methyls (MEK)
Perchlorethylene(perc)
Phenols
Trichlorethylene
5