Panasonic Viera TC-P46G25 Operating Instructions Manual page 58

Technical Information
(Continued)
IJ][e]IIIL, I nr_,_llj J][e][elllji_ _j
You can enjoy your Home theater by connecting a Dolby Digital (5.1 channel) decoder and "Multi Channel" amplifier to the
DIGITAL AUDIO OUT terminals.
(" Caution )
@ Depending on your DVD player and DVD-Audio software the copyright protection function may operate and disable optical
output.
@ When an ATSC channel is selected, the output from the DIGITAL AUDIO OUT jack will be Dolby Digital. When an NTSC
channel is selected, the output will be PCM.
@ When playing a movie on SD Card Movie player, when the sound has been recorded in Dolby Digital, the output from the
DIGITAL AUDIO OUT terminal will be Dolby Digital. When the sound is recorded in other formats, the output will be PCM.
I-" I_--]_[_
@ Aspect Ratio: 4:3
Size 1
/
Size 2
@ Aspect Ratio: FULL/JUST(H-FILL!ZOOM)
See page 34 for more information
@ The width will be decreased on both sides to
reduce noise.
@ The width will be increased on both sides to
reduce noise.
Do not display a picture in 4:3 mode for an extended period, as this can cause
"image retention" to remain on either or both sides of the display field.
To reduce the risk of such "Image retention", change the brightness of the side
bars.
See page 35 for more information
@ The side bar may flash (alternate black/white) depending on the picture.
, Side Bar
Screen
D,splay
image retenti0n _
Scrolling bar: To prevent "Image retention", scrolls white vertical bar from left to right on a black screen.
@ Press any key except the POWER key to return to previous screen.
@ You will return to the previous screen if no key operation has been performed for 15 minutes.
See page 35 for more information
[Scrolling bar]
@ Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning
frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
@ Some PC models cannot be connected to the set.
@ There is no need to use an adapter for computers with IBM PC/AT compatible D-sub 15P terminal.
@ The maximum resolution: 1,280 x 1,024
If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.
@ Signal Names for D-sub 15P Connector
Pin Layout for PC Input Terminal
Signal Name Signal Name Signal Name
_6_ GND (Ground) @ NC (not connected)
(2_ G \ri-_ GaD (Ground) @ NC
_3_ B _ GND (Ground) @ HD/SYNC
@ NC (not connected) @ NC (not connected) _ VD
GND (Ground) GND (Ground) NC
58