Panasonic Viera TC-P46G25 Operating Instructions Manual page 43

Check that the Network settings are as shown below, and then start "Connection test".
Select "Connection test" and press OK @ Displayed Connection test screen
(It takes a while to cancel the test.)
Complete Connection test
Success->Completion screen is displayed.
Error-->Follow the directions on screen to complete the setting.
If you perform the Proxy settings, check the Proxy address and
the Proxy port number.
Select Network type (Ethernet cable/Wireless (WiFi))
This setting is performed only when "Wireless (WiFi)" is selected in "Network connection" above.
_) Press "Wireless network", displayed screen
(only when "---", "No adapter" or "None" is displayed)
Set the following connection.
Please select the connection with your wireless LAN adapter and Access point.
_2_Follow the directions on screen to complete the setting
WPS (Wi-FiProtected Setup usingpush button):
Wi-FiProtected Setup is aneasysettingof theWi-FiAlliance'scertification.
Youcan connecttheAccesspoint to pressthe buttons.
WPS (Wi-FiProtected Setup usingPIN number):
Setthe PINcode thatis dispIayed on the TV on theaccesspoint.
WPS ( Wi-Fi Protected Setup using push button) (Formoredetails on settingof Accesspoint,pleasereferto operating
manual f or the Accesspoint.)
Searchfor wirelessnetworks:
Selectan accesspointfrom the onessearchedfor automatically, and
configurethesettingsas instructedon the screen.
Manualsettings:
ManualIysetSSID, Securitytype, andEncryptiontype to matchthe
settingsof the accesspoint towhich to connect.
* When connecting by 11n(5 GHz),setect"AES"as the Encryption type for
the wirelessLAN.
• Displayed Connection status with an Access point
--- : Connect with LAN cable
No adapter: Wireless LAN adapter is not installed.
None: There are no settings to connect Access point.
Connecting...: Currently connected to Access point.
If "Connected" is not displayed after a while,
set the access point connection settings again.
Connected: Complete connection.
• Displayed "Current settings and status" screen
(only when "Connected" or "Connecting..." is displayed)
You can confirm the AP connection status.
(SSID/Wireless type/Security type/Encryption type/Connection status/Signal strength)
Press "Wireless network" @ When you change "Wireless network" -->Press "No"
Follow the directions on screen to complete the setting.
(example)
You need to be "Connected" to use network devices.
Please set Access point settings to "Connected".
@
Z
(D
0
03
(D
_5"
(.C}
Oo
,,J
@ The Network settings become effective when you close the menu and run "Connection test".
43