(Mpeg2) - Panasonic D-snap SV-AV100 Operating Instructions Manual

Recording Motion Images
(MPEG2)
You can record motion images in high quality on the
Memory Card. Therefore, it is suitable for recording
important pictures.
In MPEG2 motion image recording, SD Memory
Card with the high-speed transmission rate of
10 MB/e is needed. Be sure to check available
SD Memory Card on the following web site.
For USA <http://www.panasonic.com/d-snap>
For Canada <http:llwww.panasonic.calenglishl
accessoriee/etoragemedia/>
[FINE]: 256 MB or more
[NORM]: 32 MB or more
eYou cannot record MPEG2 motion images on a card
other than the above.
1
Press the [REC/PLAY] Button to select
Recording Mode and set the operation
mode to [MPEG2].
2 Press the [MENU] Button and set [Quality]
on [Record Functions Setup] to desired
picture quality and then press the
[1_ SET] Button.
• Select one of [FINE] or [NORM].
[FINE]: High image quality 704 x 480 pixels
[NORM]: Normal image quality 352 × 480 pixels
• Press the [MENU] Button after completing the
setting.
3
Press the Recording Start/Stop Button.
• Recording starts.
• While recording the motion image, press the
Recording Start!Stop Button to stop recording.
• Be sure to clean up the SD Memory Card before
use. (-) 26)
• If you use a 32-128 MB available SD Memory Card,
when you select [Quality] on [Record Functions
Setup] to [FINE] of the MPEG2 motion image
recording mode, an error message [This card cannot
record in MPEG2 FINE mode.] appears on the LCD
Monitor. If you use a MultiMediaCard, an unavailable
SD Memory Card, or an 8 MB and 16 MB SD
Memory Card, when you select the MPEG2 motion
image recording mode, an error message [This card
cannot record in MPEG2 mode.] appears on the LCD
Monitor.
• For other notes, see page 80.
MPEG2 qlHI
_ OhOOnOOs
R Oh05m
8:00PM
_B DEC 2 02004
MPEG2 O REC
_{_ Oh0OmOOs
R Oh05m
800PM
_L_ DEC 2 02OO4
27