Power Supply - Panasonic D-snap SV-AV100 Operating Instructions Manual

Power Supply
==Using AC Adaptor
I Open the DC Input Socket Cover and
connect the DC Input Lead to the [DC IN
4.9V] socket on the SD Video Camera.
2 Connect the AC Cord to the AC Adaptor
and the AC Main socket.
==Charging the Battery
Be sure to charge the supplied battery before use.
[ While pressing the _ part, slide it to
remove the Battery Compartment Cover.
2 Press the terminals of the battery onto
the terminals of the Battery Compartment
and set the battery.
• Fit the battery with its label facing upward.
• After the battery is set, close the cover.
3 Connect the DC Input Lead to the [DC IN
4.9V] socket on the SD Video Camera.
# Connect the AC Cord to the AC Adaptor
and the AC Main socket.
• Power LampO flashes, and Charging starts.
• When recharging, turn the power of the SD Video
Camera off.
5 Wait until Power Lamp O goes off.
• When recharging is completed, Power Lamp O
goes off.
• If the Power Lamp flashes quickly (or slowly) when
recharging, recharging is not normal. (_ 78)
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the
manufacturer's instructions.
• For other notes, see pages 76, 78.
12