Lighting The Sg4C And Sg6C Ovens; Using The Sg4C And Sg6C Ovens; Error Messages - Sg4C And Sg6C Ovens - Vulcan-Hart SG4C ML-114876 Installation & Operation Manual

LIGHTING THE SG4C AND SG6C OVENS

1. Turn gas supply ON (if required).
2. Turn the gas control valve (located behind the small door on the lower front panel) ON.
3. Push Master Switch to the ON position and set Thermostat to its maximum setting. The Heat light
should come on. If Heat light is not on, make sure door is closed.
4. If the oven fails to light, push Master Switch to the OFF position. Wait 5 minutes before retrial.

USING THE SG4C AND SG6C OVENS

Refer to SUGGESTED COOKING GUIDELINES for Time, Temperature and Power Level settings.
Preheating
1. Push Master Switch ON. The Heat light will come on, indicating that power is on.
2. Set Thermostat as desired.
3. Set Power Level as desired.
4. Prepare product and place in suitable pans. When Ready light comes on, oven has reached
desired preheat temperature.
Cooking
1. Open doors and load the product into the oven. Place pans in the center of the racks. Close doors.
2. Set Roast temperature and time. Set Hold temperature and Gentle Bake time, if desired. Gentle
Bake time may not be more than Roast time. Gentle Bake will cycle the fan during the set time at
the beginning of the cooking cycle.
3. Set Power Level Control as desired.
4. Press the Start/Stop button to start the cooking cycle.
5. At the end of the cooking cycle, the buzzer will sound continuously if the Hold mode is OFF. If the
Hold mode is ON, there will be a short beep at the beginning of Second Stage Cooking (oven
temperature will begin to decline to the Hold temperature), and a long beep (20 seconds) at the end
of the cooking cycle. Refer to ROAST AND HOLD OPERATION.
6. When the product is done, open the doors and carefully remove the cooked product from the oven.
Wipe up any spills.
End of Day
1. Push Master Switch to OVEN COOL. Leave door ajar while the fan is on to cool the oven.
2. When oven has cooled sufficiently, push Master Switch OFF and clean the oven.
Extended Shutdown
Push Master Switch OFF. Turn the gas valve OFF.
ERROR MESSAGES — SG4C AND SG6C OVENS
E-01 High limit error. Contact Vulcan authorized service.
E-02 Low limit error. Contact Vulcan authorized service.
E-03 High ambient temperature, 215 F
E-04 Low ambient temperature, 32 F
E-05 Ignition failure. After trying ignition 3 times, contact Vulcan authorized service.
E-06 Thermocouple probe open. Contact Vulcan authorized service.
. Contact Vulcan authorized service.
(102 C)
. Let control warm up after cold storage.
(0 C)
– 14 –