Sony RDR-VX560 Operating Instructions Manual page 108

Theplaybackpicture or TVprogramfrom the
equipment connected t hrough the recorder i s
distorted.
If the playback picture output from a DVD
player, VCR, or tuner goes through your recorder
before reaching your TV, the copy-protection
signal applied to some programs could affect
picture quality. Disconnect the playback
equipment ill question and connect it directly to
your TV.
Thepicturedoesnotfill thescreen.
Set "TV Type" ill the "Video" setup to fit the
aspect ratio of your TV (page 98).
Thepicturedoesnotfill thescreen,even
though theaspect r atiois setin "TVType"in
"Video" setup.
The aspect ratio of the disc is fixed on your DVD.
Sound
Thereis no sound.
Re-connect all connections securely.
The connecting cord is damaged.
The input source setting on the amplifier or the
connection to the amplifier is incorrect.
The recorder is in reverse play, fast-forward,
slow motion, or pause mode.
If the audio signal does not come through the
DIGITAL AUDIO OUT (COAXIAL) jack,
check the "Audio" setup settings (page 100).
Nosound is outputfromtheHDIVII OUT jack.
Try the following: @Turn the recorder off and
on again. @Turn the connected equipment off
and on again. @Disconnect and then connect the
HDMI cord again.
The HDMI OUT jack is connected to a DVI
device (DVI jacks do not accept audio signals).
The equipment connected to the HDM! OUT
jack does not conform to the audio signal format.
Sound is noisy.
When playing a CD with DTS soundtracks, noise
will come from the LINE OUT (AUDIO L/R) or
AUDIO OUT L/R jacks (page 36).
Thesound volumeis low.
The sound volume is low on some DVDs.
The sound volume may improve if you set
"Audio DRC" in the "Audio" setup to "Wide
Range" (page 101).
Analternate audio trackcannot b erecorded or
played.
If you have connected an AV amplifier to the
DIGITAL AUDIO OUT (COAXIAL),jack and
want to change the audio track for a DVD-RW
(VR mode)/DVD-R (VR mode) during playback,
set "Dolby Digital" in "Audio" setup to "D-
PCM" (page 100).
When recording to a disc other than DVD-RWs
(VR mode)/DVD-Rs (VR mode), set "Line
Audio Input" in "Audio" setup to "Stereo."
DVDPlayback
Thedisc doesnot play.
The disc is upside down. Insert the disc with the
labeled side facing up.
The disc is not correctly inserted.
Moisture has condensed inside the recorder.
Remove the disc and leave the recorder turned on
for about half an hour until the moisture
evaporates.
If the disc was recorded on another recorder, the
recorder cannot play the disc if it was not
finalized (page 66).
Thediscdoes notstartplayback f romthe
beginning.
Resume play was activated (page 37).
You have inserted a disc whose Title menu or
DVD menu automatically appears on the TV
screen when it is first inserted. Use the menu to
start playback.
Therecorder s tartsplayingthedisc
automatically.
The DVD VIDEO features an auto playback
function.
Playbackstops automatically.
If the disc has an auto pause signal, the recorder
stops playback at the auto pause signal.
108Us