Table of Contents
Advertisement
Transmitter Programming
1 - Within three seconds turn the ignition Key ON-OFF-ON-OFF-ON - Leaving Key ON
2 - Press and hold the Program Button - Parking Lights will come ON
**if the park lights do not come on at this point, turn the key off for 5 seconds, the repeat step 1.
3 - Continue to hold the Program Button until park lights go out.
4 - Press button 1 on the remote transmitter (ensure the "#" symbol is not displayed on the LCD)
the park light will flash to confirm transmitter programming.(The "#" symbol is for Dual Car Mode)
Dual car operation:
Enter the User Programming Mode on the second remote and turn the "#" symbol on.
Program the remote (Step 1-4) After the 1st remote is programmed press button 1 on the 2nd.
Note: Transmitter programming must done quickly. Do not pause more than one second between each
transmitter. All the transmitters to be used must be programmed at the same time. All transmitters not
programmed at this time will be erased from memory for security. The system holds a maximum of 4
transmitter codes including 2nd car remote codes.
System Service Mode
ACTIVATING Service Mode (Valet)
1. While the ignition is "ON" press and hold the Program Button for five seconds. The park lights
will flash five times and the horn (optional)will honk five times to confirm that the system is in
Service Mode.
2. While in Service Mode the remote start functions will be disabled and LED's will be "ON"
steady. Door locks and trunk release are still operational.
DEACTIVATING Service Mode (Valet)
1. While the ignition is "ON" press and hold the Program Button for five seconds. The park lights
will flash two times and the horn (optional)will honk two times to confirm that the system has
exited Service Mode.
2. Remote start functions will return to normal operation.
System Service Mode (Valet) - By Remote
ACTIVATE Service Mode (User Programmable Feature)
1 - Press and hold button 4 for 3 seconds. (The remote will beep twice)
2 - Press button 1 Five times or until the ? starts flashing on the LCD screen.
3 - Press button 3 and the ? symbol will come on solid.
4 - Press button 4 to exit User Program Mode.(System Is Now In Service Mode)
DEACTIVATE Service Mode
1 - Press and hold button 4 for 3 seconds. (The remote will beep twice)
2 - Press button 1 Five times or until the ? starts flashing on the LCD screen.
3 - Press button 2 and the ? symbol will turn off.
4 - Press button 4 to exit User Program Mode.(Serice Mode is Deactivated)
Battery Replacement
When the Battery Icon on the remote indicates that the battery is low the battery should be changed
promptly. Replace with quality 1.5volt "AAA" battery.
Slide
Lift
+
-
11
1
Advertisement
Table of Contents
