Charging - Sony handycam CCD-TR91 Operating Manual

Before using your camcorder, you first need to charge and install the battery pack• To charge the battery
pack, use the supplied AC-V35 AC power adaptor.
Charging the Battery Pack
Charge the battery pack on a flat place without vibration.
(1) Connect the power cord to a wall outlet. (2) Align the right side of the battery pack wlth the line on
the AC power adaptor, then slide the battery pack in the direction of the arrow. (3) Set the selector to
CHARGE. The CHARGE lamp (orange) lights up. Charging begins.
When charging is completed, the CHARGE lamp goes out. Set the selector to the center position and
unplug the unit from the wall outlet. Then remove the battery pack and install it on the camcorder.
To stop charging, set the selector to the center position.
I
Charging Time and Battery Life
2 3
NP-55H
Battery pack (supplied)
Charging time* 70
Battery life** 60
NP-80
NP-80D
155
140
NP-77H
NP-77HD
140
135
NP-66H NP-60D
100 75
100 65
Approximate minutes to charge an empty battery pack using the AC-V35 (Lower temperatures require
a longer charging time.)
** Approximate continuous recording time (in minutes) indoors
Important!
Use the battery completely before re-charging!
Before you recharge the battery pack, make sure the battery has been used up (discharged)
completely. Repeated charging while some capacity remains causes a lowering of battery capacity.
However, the original battery capacity can be recovered if you use the battery completely and charge
it fully again.
To use up the battery, remove the cassette and slide the POWER switch to CAMERA with the battery
6 pack attached, and leave the camcorder until the _ indicator and the red lamp flash in the viewfinder.