Table of Contents
Advertisement
EggEEaag
„ ,
Charging and Installing the Battery Pack
Before using your camcorder, you first need to charge and install the battery pack. To charge the
battery pack, use the supplied AC power adaptor.
Charging the Battery Pack
Charge the battery pack on a flat place without vibration.
(1) Connect the AC power adaptor to the wall outlet.
(2)
Align the right side of the battery pack with the line on the AC power adaptor, then slide the
battery pack in the direction of the arrow.
(3)
Set the selector to CHARGE. The CHARGE lamp (orange) lights up. Charging begins.
When charging is completed, the CHARGE lamp goes out. Set the selector to the centre position and
unplug the unit from the mains. Then remove the battery pack and install it on the camcorder. To stop
charging, set the selector to the center position.
Charging Time
Battery pack
NP-66
(supplied)
NP-98/98D
NP-80/80D
NP-66H/68
NP-C65
NP-60D
Charging
time*
95
215
190
125
105
90
* Approximate minutes to charge an empty battery pack using the supplied AC power adaptor (Lower
temperatures require a longer charging time.)
6
Advertisement
Table of Contents
