Sony handycam CCD-TR91 Operating Manual page 38

On Handling Tapes
Do not insert anything in the small holes on the rear of the cassette. These holes are used to sense the
type, thickness of tape, or if the tab is out or in, etc.
Camcorder Care
• When the camcorder is not to be used for a long time, disconnect the power source and remove the
tape. Periodically turn on the power, operate the camera and player sections and play back a tape for
about 3 minutes.
• C_ean the Lens with a soft brush to remove dust. If there are fingerprints on it, remove them with a soft
cloth.
• Clean the camcorder body with a dry soft cloth, or a soft cloth lightly moistened with a mild detergent
solution. Do not use any type of solvent which may damage the finish.
AC Power Adaptor
Charging
• Repeated charging whiJe some capaclty remalns causes a lowerlng of battery oepeclty. However, the
orlglnal battery capacity can be recovered if you use the battery completely and charge it fully again.
• Charge the battery pack on a flat place without vibration.
• The battery pack will get hot during charging. This is normal.
• Video equipment cannot be operated while charging the battery pack.
Do not continuously recharge a charged battery pack as that will cause the battery peck efficiency to
deteriorate.
Charging temperature
The temperature range for charging is 5°C to 35°C (41°F to 95°F). However, to provide maximum
battery efficiency, the recommended temperature range when charging is 10°C to 30°C (5O°F to 86°F).
Others
• The AC power cord should only be changed at a qualified service shop.
• The nameplate indicating operating voltage, power consumption, etc. is located on the bottom.
• A negligible amount of electric current will flow into the AC power adaptor (even with the selector in
the center position) as long as the AC power adaptor is plugged into the wall outlet.
• Unplug the unit from the wall (mains) outlet when not in use for a long time. To disconnect the cord
(mains lead), pull it out by the plug. Never pull the cord itself.
• Do not operate the unit with a damaged cord or if the unit has been dropped or damaged.
• Be sure that nothing metallic comes into contact with the metal parts of the connecting plate. If this
happens, a short may occur and the unit may be damaged.
• Always keep the metal contacts clean.
• Do not disassemble the unit.
• Do not apply mechanical shock or drop the unit.
• While the unit is in use, particularly during charging, keep it away from AM receivers and video
equipment because it will disturb AM reception and video operation.
• The unit becomes warm while in use. This is normal.
• Do not place the unit in locations that are:
- Extremely hot or cold
- Dusty or dirty
- Very humid
- Vibrating
If any difficulty should arise, unplug the unit and contact your nearest Sony dealer.
38