Table of Contents
Advertisement
Chapter t: Getting Started
Charging and Installing the Battery Pack
Charging the Battery Pack
Notes
Option
Before you can use this camcorder, you need to charge and install the battery pack.
(, ieee
eee
(O){0)_
eae
1 Plug the AC power adaptor into a wall outlet.
2 Align the flat side of the battery pack with the lines on the AC power adaptor and the
battery pack.
3 Push down and slide the battery pack in the direction of the arrow.
4 Set the VTR (DC OUT)/CHARGE selector to CHARGE.
Required charging time:
Type of battery pack
NP-55
NP-77H
NP-77
(supplied) | NP-77HD
Required charging time | 70 | 160_|
(approx. minutes using AC-V25/V25A)
When charging is finished, the charge indicator will go out.
Important!
Use the battery completely before recharging!
Before you recharge the battery, make sure the battery has been used (discharged)
completely. Excessive charging may reduce the charging capacity of the battery.
To use up the battery, remove the video cassette and set the POWER switch to
CAMERA with the battery attached, and leave the camcorder until the CXJ indicator
appears blinking and a red lamp blinks in the viewfinder.
e Video equipment cannot be operated while charging the battery pack.
¢ The POWER lamp will remain lit for a while even if the battery pack is removed and the power cord
is unplugged after charging the battery pack. This is normal.
¢ If the POWER lamp does not light, set the VTR (DC OUT)/CHARGE selector to OFF and disconnect
the power cord. After about one minute, reonnect the power cord and set the VTR (DC OUTy
CHARGE selector to CHARGE again.
AC-S10 AC power adaptor:
This adaptor has a function which allows you to confirm that the battery is completely discharged and
ready to be recharged to its full capacity.
Installing the Battery Pack
When you have finished charging the battery, install the battery pack as follows:
6 Getting Started
Advertisement
Table of Contents
