Making Prints Using The Stack Bypass - Canon imageCLASS 2200 Reference Manual

Making Prints Using the Stack Bypass

When making prints on transparencies, or non-standard size paper stock, load the paper
1
stock in the stack bypass.
IMPORTANT
•
Note the following points when using the stack bypass:
- Copy quantity: 1 to about 50 sheets (stack about 1/4" (5mm) high)
- Paper size: 4" x 5-1/2" to 11-3/4" x 17" (100mm x 139mm to 297mm x 432mm)
- Paper weight: 17-lb bond to 32-lb (64g/m
- Curl down paper before use. (Curl amount: less than 3/8" (10mm) for normal paper; less than
•
Do not load different size/type paper at the same time.
•
LTR-size tracing paper must be placed vertically in the stack bypass. Placing this paper horizontally
may cause creases on the print, depending on the moisture absorption condition of the paper.
•
LTR-size transparencies must be placed vertically in the stack bypass. Placing this paper
horizontally may cause blurred images.
•
When making two-sided prints, select the Two-sided mode. Not selecting the correct mode may,
cause creases on the print, depending on the moisture absorption condition of the paper.
•
To print on the rear side of printed paper, it is recommended you load the paper in one of the paper
drawers.
•
When printing on envelopes, empty the output tray when at most 10 printed envelopes accumulate in
the tray.
•
When you select "Free Size" for copying, you cannot use the Auto Zoom, Entire Image, Finisher,
Hole Punch, 1 2-Sided, 2 2-Sided, Book 2-Sided, Two-page Separation, Cover/Sheet
Insertion, Shift (Center/Corner), Booklet, Transparency Interleaving, Image Combination, Image
Separation, or Image Repeat modes.
•
When you select "Free Size" for printing documents stored in the mail box, you cannot use the
Finisher, 2-Sided, Document Contiguous/Separate Duplex Printing, Cover/Sheet Insertion, or
Booklet modes.
NOTE
•
When scanning the following originals, you cannot use Automatic Paper Selection. Use Manual
Paper Selection with these types.
- Highly transparent originals such as transparencies
- Originals with an extremely dark background
Standard Size
You can select standard inch paper, or A or B series paper.
1-46

Making Prints Using the Stack Bypass

1/4" (5 mm) for heavy paper.) There are some types of paper stock which may meet the above
specifications but cannot be fed in the stack bypass.
2 2
to 128g/m )