Command 6 - Multimeter Mode Setup - Casio CFX-9850G User Manual

Chapter 3: Commands and Programming
DATA RANGE SETUP Examples
{5,1,2}
{5,2,0,256,300}

Command 6 - MULTIMETER MODE SETUP

Command 6 specifies a channel for multimetering. Only one channel (the
one you specify) is enabled in the Multimeter Mode at a time.
Syntax
{6, Set/Reset, Channel Select, Operation}
Set/Reset Parameter
This parameter executes a Multimeter Mode set or reset operation. The initial
default for this parameter is 1.
The following points apply whenever the data analyzer is in the Multimeter
Mode.
Channel Select Parameter
This parameter selects a channel for measurement.
54
• Pressing the [MODE] key and entering the Multimeter Mode makes it
possible to use the data analyzer as a stand-along measuring instru-
ment without commands from a graphic scientific calculator.
0 Returns to the Communications Mode
1 Enters the Multimeter Mode
• Command 6 with a set/reset parameter of 0 is the only valid command
accepted by the data analyzer.
• The default sample time is approximately 1 second.
• Sampling results appear on the display, but are not sent to a connected
calculator.
1 Channel 1 (CH1)
2 Channel 2 (CH2)
3 Channel 3 (CH3)
5 = DATA RANGE SETUP
1 = Transfer data from CH1
2 = Filtered d 2 /dt 2 data (when filtering is turned on
with Command 1)
5 = DATA RANGE SETUP
2 = Transfer data from CH2
0 = Filtered raw data (when filtering is turned on
with Command 1)
256 = Starting sample number
300 = Ending sample number