Maintenance Schedule - Superior SDVST-N-B Care And Operation Instructions Manual

MAINTENANCE SCHEDULE

Annually (Before the onset of the Burning Season)
MAINTENANCE TASK
Inspect/Clean Burner, Logs
and Controls
Check Flame Patterns and Flame
Height
Inspect/Clean Pilot and Burner
Check Vent System
Appliance Checkout
Replacing Glowing Embers
Periodically (After the Burning Season)
MAINTENANCE TASK
Clean Firebox Interior
Check Flame Patterns and Flame
Height
Check Vent System
Clean Front Glass Enclosure Panel
ACCOMPLISHING PERSON
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Homeowner/Qualified Service
Technician
ACCOMPLISHING PERSON
Homeowner
Homeowner
Homeowner
Homeowner
PROCEDURE
Inspect valve and ensure it is properly operating. Check piping
for leaks. Vacuum the control compartment, fireplace logs and
burner area.
Refer to Figures 5 and 9 on Pages 12 and 13 and verify the
flame pattern and height displayed by the appliance conforms
to the picture. Flames must not impinge on the logs. Ensure
flames are steady (not lifting or floating).
Refer to Figure 11 on Page 14. Remove any surface build-up
on pilot and burner assembly. Wipe the pilot nozzles, igniter/
flame rod and hood. Ensure the pilot flame engulfs the flame
sensor as shown.
Inspect the vent system at the top and at the base (within the
firebox) for signs of blockage or obstruction. Look for any signs
of dislocation or deterioration of the vent components. Note:
Excessive condensation can cause corrosion of caps, pipe &
fittings (excessive condensation can be caused by long lateral
runs, too many elbows and/or exterior portions of the system
being exposed to cold weather). Also inspect wall straps or
plumbers's tape to ensure it is secure and in place.
Perform the appropriate appliance checkout procedure detailed
in this manual.
Remove old ember materials (rockwool) and vacuum the ember
placement area. Place new embers as described on Page 12.
PROCEDURE
Carefully remove logs, embers (rockwool) and volcanic stone.
Vacuum out interior of the firebox. Clean firebox walls and log
grate. Replace logs, embers and volcanic stone as detailed in
this manual.
Refer to Figures 5 and 9 on Pages 12 and 13 and verify the
flame pattern and height displayed by the appliance conforms
to the picture. Flames must not impinge on the logs.
Inspect the vent system at the top and at the base (within the
firebox) for signs of blockage or obstruction. Look for any signs
of dislocation of the vent components.
Clean as necessary following the directions provided in this
manual. DO NOT TOUCH OR ATTEMPT TO CLEAN GLASS
WHILE HOT.
21