Maintenance Schedule - Superior DRT63STYN Installation And Operation Instructions Manual

INNOVATIVE HEARTH PRODUCTS • SEE-THROUGH POWER VENT DV GAS FIREPLACES (DRT63STYN) • INSTALLATION INSTRUCTIONS

MAINTENANCE SCHEDULE

WARNING: BURN HAZARD.
Turn OFF gas and electrical power to the fireplace, and
allow it to cool before cleaning or servicing the appliance.
Annually (before onset of burning season)
MAINTENANCE TASK
Inspect/Clean Burner, Logs,
and Controls
Check Flame Patterns and Flame Height
Inspect/Clean Pilot and Burner
Check Vent System
Appliance Checkout
Replace Glowing Embers
Periodically (after burning season)
MAINTENANCE TASK
Clean Firebox Interior
Check Flame Patterns and Flame Height
Clean Front Glass Enclosure Panel
54
ACCOMPLISHING PERSON
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Homeowner/Qualified Service
Technician
ACCOMPLISHING PERSON
Homeowner
Homeowner
Homeowner
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
PROCEDURE
Inspect valve, and ensure it is operating properly.
Check piping for leaks.
Vacuum the control compartment, fireplace, logs, and burner area.
Refer to Figures 21 and 22 on Page 16 and verify the flame pattern and
height displayed by the appliance conform to the illustration. Flames must
not impinge on the logs. Ensure flames are steady (not lifting or floating).
Refer to Figure 23 on Page 16. Remove any surface build-up on pilot
and burner assembly. Wipe the pilot nozzles, igniter/flame rod and hood.
Ensure the pilot flame engulfs the flame sensor as shown.
Inspect the vent system at top and base (within the firebox) for signs
of blockage or obstruction.
Look for any signs of dislocation or deterioration of the vent components.
Reconnect or replace, as necessary.
Note: Excessive condensation can cause corrosion of caps, pipe
and fittings (excessive condensation can be caused by long lateral
runs, too many elbows and/or exterior portions of the system being
exposed to cold weather). Also inspect wall straps or plumbers's
tape to ensure it is secure and in place.
Perform appropriate appliance checkout procedure, as detailed in this
manual.
Remove old glowing ember material, and vacuum the ember placement
area. Place new glowing embers, per instructions on Page 13.
PROCEDURE
Carefully remove logs, glowing ember material, and volcanic stone.
Vacuum out interior of the firebox.
Clean firebox walls and log grate.
Replace logs, glowing embers, and volcanic stone, as detailed in this
manual.
Refer to Figures 21 and 22 on Page 16 and verify the flame pattern
and height displayed by the appliance conforms to the picture. Flames
must not impinge on the logs.
Clean as necessary following the directions provided in this manual.
DO NOT TOUCH OR ATTEMPT TO CLEAN GLASS WHILE HOT.