System Memory; Supported Memory Configurations - Intel DCCP847DYE Specification

1.4

System Memory

The board has two 204-pin SO-DIMM sockets and supports the following memory
features:
• 1.5 V DDR3 SDRAM SO-DIMMs with gold plated contacts
• Support for 1.35 V Low Voltage DDR3 (new JEDEC specification)
Two independent memory channels with interleaved mode support
•
Unbuffered, single-sided or double-sided SO-DIMMs
•
16 GB maximum total system memory (with 4 Gb memory technology). Refer to
•
Section 2.1.1 on page 35 for information on the total amount of addressable
memory.
Minimum recommended total system memory: 1024 MB
•
• Non-ECC SO-DIMMs
Serial Presence Detect
•
XMP profile support for voltage detection
•
DDR3 1333 MHz and DDR3 1066 MHz SDRAM SO-DIMMs
•
NOTE
To be fully compliant with all applicable DDR SDRAM memory specifications, the board
should be populated with SO-DIMMs that support the Serial Presence Detect (SPD)
data structure. This allows the BIOS to read the SPD data and program the chipset to
accurately configure memory settings for optimum performance. If non-SPD memory
is installed, the BIOS will attempt to correctly configure the memory settings, but
performance and reliability may be impacted or the SO-DIMMs may not function under
the determined frequency.
Table 5 lists the supported SO-DIMM configurations.
Table 5. Supported Memory Configurations
Raw Card SO-DIMM
Version Capacity
1 GB
A
2 GB
1 GB
B
2 GB
512 MB
C
1 GB
2 GB
F 4 GB
8 GB
Note: System memory configurations are based on availability and are subject to change.
DRAM Device DRAM
Technology Organization
1 Gb 64 M x 16
2 Gb 128 M x 16
1 Gb 128 M x 8
2 Gb 256 M x 8
1 Gb 64 M x 16
2 Gb 128 M x 16
1 Gb 128 M x 8
2 Gb 256 M x 8
4 Gb 512 M x 8
Product Description
# of DRAM
Devices
8
8
8
8
4
4
16
16
16
19