Epson 3865X Plus User Manual page 273

Make sure you save your password setting and that you
highlight
the Setup program.
4. After you exit Setup, you see this message:
TURN OFF POWER AND CORRECT JUMPER
SETTING TO ENABLE PASSWORD CHECKING
5. Remove the Reference diskette, turn off the computer, and
follow the instructions under "Changing the Jumper
Settings" in Chapter 5 to enable the password function by
setting jumper J1 to position A.
6. If you do not have a hard disk, insert the Startup diskette in
drive A. Turn on the computer. You see the key prompt
the key prompt. Enter your new password to access the
system. (See "Using the Power-on Password" in Chapter 3.)
Note
Be sure to remember your new password or write it down and
keep it in a safe place. If you forget the
now, you may have to repeat the procedure above the next
time you turn on your computer.
D-12 Troubleshooting
** EXIT AND SAVE ** when you leave
you enter