Star Trac Fitness E-Series User Manual page 22

STEP 11.
While holding the new center console near the opening of the display, connect the following cables
to there appropriate connector. (There is no particular order):
Plug in the (2) DC power cables to
•
matter which goes to which).
Plug in the PVS remote cable to the
•
Plug in the A/V cable to the audio (6-pin) and the video (2-pin) connector, respectively, to the
•
A/V connectors on the center console board.
4
Take the keypad tail, and the
•
window.
STEP 12.
Close the center console. Using a #2 Phillips
screwdriver, take the screws retained from earlier
and screw in the (4) screws from below that hold
in the center console. Tighten the screws snug.
22
1
the DC connectors, (they are the same so it does not
2
PVS remote connector.
5
center console ground and feed them through the cable
3
620-7991 Rev 002