Star Trac Fitness E-Series User Manual page 20

STEP 4. (E-TR ONLY)
Using a #2 Phillips screwdriver, remove the
screw that holds in the blank headphone jack
cap at the lower front of the display. Retain the
screw.
You will no longer need the cap and, if desired, you
can store it away for any possible future use.
Now take the headphone jack from the iPod®
CC hardware kit. Connect the headphone jack
to the cable in the jack opening. Use the previ-
ously retained screw to reinstall the headphone
jack. Tighten snugly.
STEP 5.
Detach the center console ribbon cable from the
display board by gently pulling on the ribbon
connector. Using a #2 Phillips screwdriver to
remove the (4) screws that hold the center con-
sole in place. Retain the screws for later use.
Remove the center console.
need this center console and, if desired, you can
store it away for any possible future use.
STEP 6.
Take the Personal Viewing Screen from the
PVS kit. Next, take the (3) M8 buttonhead
screws, the M8 Hex nut with washer, and the
5mm Hex key from the PVS hardware tool kit.
Mount the Personal Viewing Screen on the
treadmill. Using the 5mm Hex key, screw in the
(2) M8 buttonheads at the base of the PVS first
(do not tighten yet). Using the 5mm hex key put
one of the M8 buttonhead screws into the hole
on the PVS neck, then put the Hex nut with
washer on the back side (do not tighten).
STEP 7.
Adjust the display cap up or down to align with
the holes on the display front. Once the cap is
aligned, tighten all three buttonhead screws
with the 5mm hex key.
20
You will no longer
620-7991 Rev 002