Star Trac Fitness E-Series User Manual page 15

With the changes now completed on the display, it is now time to re-install the display console to the
base unit. There are the (3) cables from the PVS mount that will need to be attached to the display.
One cable from the PVS mount will be fed through the display which will be connected to the head
phone jack later. The fifth cable from the PVS mount, which is the coax, will be connected to the
coax on the base unit. There are (2) cables from the base unit that will be connected to the display.
Use the image below to help reference the needed points on the display.
STEP 16.
Take the coax cable from the PVS mount and
attach it to the coax cable on the base unit.
Tighten the connectors snug to each other.
STEP 17.
Now take the 5" silicon wrap from the kit and
peel off its protective tape then wrap the two
connectors so that all of the metal surface is
covered
STEP 18.
Using a 5" tie wrap from the PVS kit, bind the
cables from the PVS neck to one side of the
display mount. Take the tie and put it through
the hole on one of the display mount tubes.
STEP 19.
Now, take the front display plastics with the new
center console to the base unit. Hold the front
display plastics at the top with one hand while
connecting the cables/harnesses with the other.
There is no particular order in connecting the
cables. However, it may be best to start off con-
necting the cables/harnessing coming from the
neck of the base unit.
15
620-7991 Rev 002