Sony PMW-F3K Operating Instructions Manual page 117

VIDEO SET
Menu items Setting values
SDI/HDMI Out On / Off
Display
Setting the
character
information for
digital outputs
Video Out On / Off
Display
Setting the
character
information for the
composite output
Down Squeeze / Letterbox / Edge
Crop
Converter
Selecting the
operation mode of
the down converter
23.98P Output
59.94i (2-3 Pull Down)/
23.98PsF
Selecting Output
mode
Dual-Link & Off / 1.5G YPbPr422 & Video
Gamma Select
Setting the dual-
link output
S-Log LUT Off / On
Setting MLUT
mode for S-Log
output
Contents
Set whether to add the same menus and status indications as
those on the LCD monitor/viewfinder screen to the output
signals from the SDI OUT and HDMI OUT connectors.
Note
On the thumbnail, EXPAND CLIP and SHOT MARK
screens, the same menus and status indications as those on the
LCD monitor/viewfinder screen are displayed regardless of
the setting of this item.
Set whether to add the same menus and status indications as
those on the LCD monitor/viewfinder screen to the output
signal from the VIDEO OUT connector.
Note
On the thumbnail, EXPAND CLIP and SHOT MARK
screens, the same menus and status indications as those on the
LCD monitor/viewfinder screen are displayed regardless of
the setting of this item.
Set the output mode (aspect) for SD signals
Squeeze: To horizontally reduce a 16:9 picture to output a 4:3
picture
Letterbox: To mask the upper and lower areas of a 4:3 picture
to display a 16:9 picture in the center of the screen
Edge Crop: To cut the both sides of a 16:9 picture to output a
4:3 picture
Select the video output format when the video format is HQ
1920/23.98P or HQ 1440/23.98P (invalid with video formats
other than HQ 1920/23.98P and HQ 1440/23.98P).
Set the output from the HD SDI A/B connectors.
Off: No signal output
1.5G YPbPr422 & Video: To output 1.5G Dual-Link HD-SDI
signal using both the A and B connectors.
Note
The following choices become available when the CBK-
RGB01 RGB and S-LOG Output Option is installed.
1.5G YPbPr422 & S-Log
1.5G RGB444 & Video
1.5G RGB444 & S-Log
3G YPbPr422 & Video
3G YPbPr422 & S-Log
3G RGB444 & Video
3G RGB444 & S-Log
Set the MLUT mode for S-Log output.
Off: To not apply MLUT (To output original S-Log)
On: To apply MLUT selected with "S-Log LUT Select" or
"S-Log EI Select"
Setup Menu List 117