Network; Email - Digimerge Touch DH200 Series Instruction Manual

NETWORK

Configure network and DDNS
options.
Figure 18.0 Network menu (IP setup)
To configure IP Setup:
1. Connect an Ethernet cable to the LAN port
on the rear panel of the system.
2. Disconnect the power cable and let the
system power down for a few moments.
Reconnect the power cable. The system
automatically powers on.
3. Under CONFIG, select
DHCP allows you to instantly obtain an IP
address when first networking your
system. STATIC IP lets you manually enter
a fixed IP address. If you select STATIC, go
to step 4.
NOTE: DCHP allows you to quickly connect to
your network by obtaining an IP address from
the router. After the initial setup, we recommend
that you disable DHCP and set the IP address
between 1~100. For example, if your IP address
is 192.168.0.107, change the last digits to 90 (i.e.
192.163.0.90). This ensures that port forwarding
will not change in the event of power failure or
resetting of your network.
4. Press to save your settings. Press
ENTER
to close remaining menu
CANCEL/ESC
windows.
or .
STATIC DHCP

EMAIL

Configure settings for email notification of
events on the system.
Figure 18.1 Email menu
To configure email settings:
1. Under USE, select
own email server). If you select DEFAULT,
go to step 7. If you select SMTP, go to step
2.
2. Under SMTP SERVER, enter your SMTP
email server.
3. Under SMTP PORT, enter your SMTP port.
4. Under SMTP AUTH, select
5. Under SMTP USER ID, enter your SMTP
.
user name
6. Under SMTP PASSWORD, enter your
.
password
7. Under EMAIL ADDRESS, enter the
recipient email address for the email
notification. You can add up to five email
addresses.
8. Press to save your settings. Press
ENTER
to close remaining windows.
CANCEL/ESC
When an event is triggered, you will
NOTE:
receive an email alert. If no events occur in
the next 5 minutes, you will no receive
another email.
If a new event is triggered during that
minutes, you will only receive the new email
5 minutes after the first email.
Using the Main Menu
or (your
DEFAULT SMTP
.
ON
SMTP
27