Power Supply; Removing And Replacing The Power Supply - Gateway E-5400 System Manual

Power supply

Removing and replacing the power supply

To remove the power supply:
1
Turn off the system and disconnect the power cord and modem cord, if
installed.
2
Open the case by following the instructions on page 17. (See "Preventing
static electricity" on page 15.)
3
Lay the case on its right side, if possible.
4
Locate and disconnect the power supply connectors from all internal
devices, including the 3.5-inch diskette drive, the CD-ROM drive and all
hard drives.
5
Locate and disconnect the main power supply connector to the system
board, by pressing on the tab to release the connector, then gently pulling
the connector from the board.
52
System Components