Panasonic PT-EX12KU Operating Instructions Manual page 94

Maintenance/replacement
(ii) Change the water two or three times while you rinse the air filter.
•■Rinse it until the cloud of the water clears. If the air filter is not rinsed sufficiently, odor may result.
■
z Drying the air filter
Naturally dry the air filter in a well-ventilated place, avoiding dust and direct sunlight.
•■Do not use a hair drier or other drier.
4) Attach the air filter.
■
z Insert the air filter with its tabs facing down.
5) Slide the air filter cover to the original position.
■
z Perform Step 1) in the reverse order.
6) Reset the filter counter.
■
z Turn on the power and perform [Filter counter reset] in the [Setting] menu.
Attention
■
z After washing the air filter, dry it thoroughly before attaching to the projector. Attaching wet air filter may cause
electric shock or malfunction.
Note
■
z Be sure to attach the air filter properly. If you use the projector without attaching the air filter, the projector may
be damaged due to the dirt or dust.
■
z If the air filter has been damaged or dirt remains even after washing it, replace it with a a new filter (Product
No.: ET-RFE12).
■
z It is recommended that the air filter is replaced after two times of cleaning and reusing.
■
z After washing, the capability of the air filter may decrease.
■
z After washing the air filter, reset the filter counter. Otherwise, the power of the projector may be turned off for
safety.
94 - ENGLISH