Panasonic PT-EX12KU Operating Instructions Manual page 91

■ When there is a problem with the lamp ■
The status of the indicator is displayed with the following symbols.
s: Off, ●: On, H: Flashing, ■: On or Flashing
Indicator
<WARNING
<POWER> <STANDBY>
TEMP.>
Green Red
Red
*1 *1 *1
■ ■ ■
*1 *1 *1
■ ■ ■
*1: The indicator will turn on or flash under certain conditions, regardless of the status of other indicators.
*2: The indicator will flash in approximately 1-second intervals.
Note
■
z The status of each lamp can be checked as the lamp indicators <LAMP 1 REPLACE>/<LAMP 2 REPLACE>
on the front of the projector turn on or flash. (
■ When there is a problem with the shutter ■
The status of the indicator is displayed with the following symbols.
s: Off, ●: On, H: Flashing, ■: On or Flashing
Indicator
<WARNING
<POWER> <STANDBY>
TEMP.>
Green Red
Red
*1 *1 *1
■ ■ ■
*3
s H s
s ● s
*1: The indicator will turn on or flash under certain conditions, regardless of the status of other indicators.
*2: The indicator will flash in approximately 0.5-second intervals.
*3: The indicator will flash in approximately 1-second intervals.
Note
■
z The status of each lamp can be checked as the lamp indicators <LAMP 1 REPLACE>/<LAMP 2 REPLACE>
on the front of the projector turn on or flash. (
<LAMP 1
<WARNING REPLACE>/
<SHUTTER>
FILTER> <LAMP 2
Blue
Orange REPLACE>
Orange
*1 *1 *2
■ ■ H
*1 *1
■ ■ ●
page 96)

<LAMP 1
<WARNING REPLACE>/
<SHUTTER>
FILTER> <LAMP 2
Blue
Orange REPLACE>
Orange
*1 *2 *1
■ H ■
*2 *1
s H ■
*1 *2 *1
■ H ■
page 96)

About indicator status
Status of the projector
Either or both of the lamps do not turn on. (If both
of the lamps fail, they are cooling down. After the
standby indicator <STANDBY> turns on again, press
the power <POWER ON> button on the remote control
or the power button on the control panel.)
The recommended time to replace the lamp has been
reached.
The will be displayed at the top right of the screen
to notify the user of replacement.
Replace the lamp unit as soon as possible. Replacing
the lamp will cause the lamp indicator <LAMP 1
REPLACE>/<LAMP 2 REPLACE> to turn off.
Status of the projector
The shutter cannot be opened or closed. The lamp will
turn off, cooling will begin and the projector will switch
to the standby mode. The power will turn on and the
projector will attempt to open the shutter automatically
up to three times. After three failed attempts, the
projector will switch to the standby mode after the
lamp has cooled.
There is a problem with opening or closing the shutter,
and the lamp has turned off and is cooling down.
There is a problem with opening or closing the shutter,
and projector will switch to the standby mode after the
lamp has turned off and cooled down.
ENGLISH - 91