Connecting Example: Av Equipment - Panasonic PT-EX12KU Operating Instructions Manual

Connecting example: AV equipment

Attention
■
z Always use one of the following when connecting a VCR.
–■A VCR with built-in time base corrector (TBC)
–■A time base corrector (TBC) between the projector and the VCR
■
z If burst signals are connected to nonstandard signals, the image may be distorted. In such a case, connect a
time base corrector (TBC) between the projector and the device.
Note
■
z Use an HDMI High Speed cable that adheres to the HDMI standard. Use of a cable that does not adhere to the
standard may result in abnormal operation such as cut-out of the image, failure to project, etc.
■
z The <HDMI IN> terminal can be connected with an external device with a DVI terminal using an HDMI/DVI
conversion cable. With some devices, however, normal operation may not be possible and images may not
appear. ( page 76)

■
z The <DIGITAL IN> terminal can be connected to HDMI and DVI-D compatible devices, but normal operation
may not be possible with some devices and images may not appear.
■
z The <DIGITAL IN> terminal (in the digital signal input mode) is compatible only with single link signals.
Connections
ENGLISH - 37