B.4 Cable Connector; Figure B.3 Correspondence Between Upc Interface And Signal Cable Pins; Cable Connector - Fujitsu PRIMEQUEST 1000 Series Hardware Installation Manual

PRIMEQUEST 1000 Series Hardware Installation Manual
APPENDIX B UPC Interface
B.4

Cable Connector

This section describes the connector type and the correspondence between the UPC interface and the signal cable
pins.
Connector type
D-SUB9 male connector (receptacle: female)
Pin assignment
The figure below shows the UPC interface and pin assignment of the signal cable.
Unused pins (pins 1, 2, 3, 4, and 8 in the
The pin assignment on the cable side is as shown below.

FIGURE B.3 Correspondence between UPC interface and signal cable pins

FIGURE B.2 Connection of the main unit and
86
CVCF) must not be used.
C122-H004-07EN