Default Settings; The Overview System Default Settings - Fujitsu PRIMERGY BX600 User Interface Description

The overview system default settings

9 Default Settings

9.1 The overview system default settings
The default settings for the system module are shown in the following table.
Management
CLI
HTTP
SNMP v1/v2c/v3
System
Management VLAN
WEB Management
Traps
SNMP Communities
User Name
Password
Serial Port
IP Settings
Port Status
Admin Status
Negotiate
Port Speed
Duplex Mode
Flow Control
Port Priority
SSH
281
serial port / telnet / ssh
Java Applet / SSL3.0 , TLS 1.0
Enterprise MIBs / Standard MIBs / RMON
VLAN 1
HTTP Mode (Unsecure): Enabled
HTTP Port: 80
Authentication Flag............................ Enable
Link Up/Down Flag.............................. Enable
Multiple Users Flag............................ Enable
Spanning Tree Flag............................. Enable
DVMRP Traps.................................... Disable
OSPF Traps..................................... Disable
PIM Traps...................................... Disable
public : Read Only
private : Read/Write
admin
admin
baud rate 9600
IP address and netmask: 0.0.0.0 0.0.0.0 on VLAN 1
enable
enable
port1~10 : 1G
port11~16 : 10/100/1G
port17~18 : 10G
port1~10 : full
port11~16 : half / full
port17~18 : full
disable
Administrative Mode: .......................... Disabled
Protocol Levels: .............................. Versions 1 and 2
Default Settings
Intelligent Blade Panel Module