Default Settings; Switch Mode - Fujitsu PRIMERGY 10/40GbE User Manual

⑪ Connect the modules and cables
⑫ Set back the configuration such as remote notification/alarm service in your system.

4 Default Settings

4.1 Switch Mode

Item
Switching method
Port information
ETHER port
Data transfer rate
Full/half duplex
Flow control
VLAN
Protocol VLAN
Predefined protocol
Link down relay
Link aggregation
Load balancing algorithm
Back up port
Port selection scheme
STP information
STP operating mode
LLDP
Broadcast/Multicast storm control
Converged Enhance Ethernet
Output rate control
Reflective Relay
IGMP snooping
MLD snooping
IEEE802.1X authentication
RADIUS client
TACACS+ client
LDAP Client
IP interface
  Password information
User name
Password
ACL information
SNMP information
DHCP/DNS client
telnet/SSH auto logoff
Console auto logoff
System log information
System log send
Facility
Priority
Automatically current time set
Default Setting
Cut through switching
1-18 19-26
(Downlink) (Uplink)
10Gbps 10Gbps
Full-duplex Full-duplex
(Fixed) (Fixed)
Tx:OFF, Rx:ON
VID 1 (no tag)
IPv4、IPv6
Disabled
Destination MAC address, Source MAC address
Master port preferred
MSTP enabled for Uplink ports / Disabled for downlinks
Disabled
Enabled
Threshold value: 7.5Mpps
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
In-band = None/OOB = DHCP
admin
admin
None
Disabled
Enabled on oob
5 min
8 hours
Disable
23（local7）
error、warn、info
TIME or SNTP protocol advertised by DHCP server
Page 15 / 23
PRIMERGY 10/40GbE Connection Blade 18/8+2 User Guide
27,31
(Uplink)
（MMB connection
40Gbps 10/100Mbps
(Auto-detect)
Full-duplex Auto-detect
(Fixed)
Tx:ON(Fixed)
Rx:ON(Fixed)
－
oob
link）